I looked at their code but I can't figure out what to do. Please be sure to look at that website above. Here is a great website that does just what I'd like: When your front is a line, you can also setup a slope, so that start- and endpoint are on different heights. For that, activate the box Set Height, and adjust the height using the slider. So my question is how do I make the front shorter than the back, with the back having consistent background color and overflow that fully shows and doesn't leave the background. In FWsim Pro, it is possible to change the height of fronts. I tried to Google this but only found one site they didn't quite cover what I need. I've tried adjusting the heights, but I'm running into issues with overflow, etc. It flips perfectly, but I'd like to make the front side of the card smaller than the back. Regions with constant pressure do not cause wind, but if there is an imbalance of pressure then air will move to reduce it, and hence flow along the (negative) gradient until the pressure difference is removed. ![]() I have a flip card, which I've built using CSS. This is a hint of what is going on: what matters is not pressure, but pressure differences.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |